Smart Tips to Sterilize Contact Lenses

In order to avoid getting eye infections, it is very important for you to sterilize your contact lenses properly before wearing. Basically, there are available two types of contact lens which are soft contact lenses and hard contact lenses. One of the types might be used for once only, while another type can be reused for varying lengths of times like week or month. The disinfection solution is specifically designed to sterilize the contact lenses. Also, some of disinfection solutions are proposed to clean lenses overnight while the others can be used for sterilizing the lenses in a matter of minutes.

Minutes

Firstly, you should read the instruction label of disinfecting solution. By using some cleaning solutions, you have to wait for at least six hours before you are going to put the lenses onto your eyes. In order to immediately insert the lens after cleaning, you need to look for a multipurpose disinfecting solution which does not require that you wait for six hours.

Secondly, you need to wash your hands using hot water and soap before you are going to handle the contact lenses.

Thirdly, the contact lens in the palm should be placed in the palm of your hand and then spray with the multipurpose disinfecting solution. Based on the instructions from your doctor about your specific contacts, it may be instructed for you to rub the contacts gently as you apply the solution.

Fourthly, you need to rinse the each side of your contact lens in the solution. You can do it at least five seconds for each side. Actually, it depends on the brand of the multipurpose disinfecting solution you want to use.

Hours

Firstly, you have to read the instruction label of disinfecting solution in order to make sure that you are certainly using the correct solution. This is typically a "no rub" disinfectant and if you apply it to the lens you cannot put your contact lens onto the eye for at least six hours.

Secondly, you need to wash your hands using hot water and soap before you are going to handle the contact lenses.

Thirdly, you need to place your contact lenses into the special container which comes with heavy duty cleaner. It can be a small vile that comes with a screw-off lid and also an insert that can flip up with the concave holder for placing each contact.

Fourthly, you should pour the solution into the container, then filling to the fill line and affix the lid. You have to make sure that the solution should fizz.

Lastly, you need to wait for at least six hour before you put back the lens onto your eye.



Article Source: